3D Drucker Teile & Zubehör

Trianglelab Hochpräziser Z-Sonden-Automatik-Bett-Nivellierungssensor-Kit 3D-Touch-Sensor Kossel Delta Z-Achse 3D-Drucker für MK8

24,90 €

inkl. 19 % MwSt. auf die Ware; bestätigter Versand nach Deutschland enthalten

Lieferung nach Deutschland
Lieferzeit: 7–12 Tage

Angezeigter Planpreis. Bestellungen sind noch nicht freigeschaltet.

Produktbeschreibung

This product is an auto bed leveling kit using membrane switch technology.
Nozzle contact is a direct measurement,the nozzle is the 'sharp end of the tool'.Since there are no x and y offsets(and very minimal z-offset)the whole of the printable area of the bed can be probed.It is light weight and removable will not add any mass to your printhead.The firmware setting is simplest of all the autobed leveling method.
1.Can be used with any printing surface including Printbite,PEI,Buildtak,Glass,Aluminium,FR4.
2.Uses a standard endstop connector
3.Voltage comparator module can provide repeatable and stable single output
4.Very easy to configure in your firmware
5.No X or Y offsets,your nozzle is the tool head,so use the nozzle to probe
6.Low cost and easy to use.
1.
Connect the sensor to thePCB module
2.
Connect the PCB module to you mainboard probe endstop
VCC to endstop+
GND to endstop-or GND
DO to probe signal pin defined in your firmware
The signal is
LOW
when the porbe sensor is triggered.
It is ok to connect the sensor direct to GND and probe signal pin if you
have and trouble about theVoltage comparator PCB module.