EAFC 12V Car Jump Starter Power Bank Portable Car Battery Booster ChargerStarting Device Auto Emergency Start-up Lighting

NOTE

The Peak current 600A is suitable for gasoline vehicles up to 3L

The Peak current 1200A is suitable for petrol cars up to 4L and diesel cars up to 2L

The Peak current 2000A is suitable for petrol vehicles up to 6L and diesel vehicles up to 4L

Matters needing attention (buyers must see)

The product has just been received, you must first turn on the flashlight to discharge(Press and hold the power button for 3s+ to turn on the flashlight discharge mode) Discharge completed then charge the product for more than 4 hours, and then start the car, because the product is empty. This operation can prolong the service life of the product!

1.It takes about 4 hours for the product to be fully charged.

2.It is recommended to start the car with three bars or more than 60% of the power supply

3. Check whether the pile head of the battery is clean

4.Start the car with ordinary clip: Check whether the blue port of the clip is inserted to the end, whether the clip touches the positive and negative poles of the battery with the largest area, and whether the clip is stable and does not shake. First, clip the positive and negative poles of the clip to the positive and negative poles of the battery On, wait 2 to 3 minutes before starting the car. This operation can reduce the load on the power supply

5. our car power supply has the difference between the peak value 2000A and the peak value 1200A.

6. The product is not used for a long time. It is recommended to charge it once every 3 months.

7.The product needs to be placed at room temperature, which is beneficial to the service life of the product.

Tips before use

【1】The car cannot be continuously ignited to start the car / or the key is not released, and the next start will be carried out after 1min between each start

【2】The positive and negative poles cannot be reversed. Two clips cannot be connected short-circuited.

【3】Remove the clip within 30 seconds after successfully starting the car.

Violation of the above 3 points may cause the [fuse box] of the clip to burn out, please pay attention to the operation method.

Feature

Question1: Why does the battery level always show 0% after I charge it for a long time?

Answer: Due to the long-term power loss of the power supply, the product enters the self-protection mode. Please charge for more than 4 hours. It takes a long time for the power level to go from 0% to 1%. This is normal.

Question2: Why does the battery level show 100% when I turn it on and then turn it back to 0%?

Answer: Same as the above question, at this time you can long press the button to turn on the flashlight discharge mode, After discharge is completed and then recharge the power supply until it reaches 100%

Specifications

Peak Current:1200A/2000A

Starting Current:600A/1000A

Car Jump Start Output:12V

USB Output 5V/2A

Gas Engine Rating:Up to 4.0L

Operating Temperature:-20℃-60℃

Diesel and steam double start strong power

Night emergency, Rescue lighting

1. Built-in glare lighting system.

2. Double click to enter,red and blue flashes,double click again to exit.

3.Long press the middle button for 3 seconds.

Press again in burst mode.

4. After turning on the flashlight,press the switch again to become a flash,the switch is the distress mode.

Packing List

1*Battery clip

1*Instruction

1*USB cable

1*Jump Starter

🚗 How to Jump Start Your Car